Transport; Storage; Care And Maintenance; Troubleshooting - Kärcher NT 48/1 Te Originalbetriebsanleitung

The vacuum cleaner is now ready. You can
now switch on the electrical power tool.
Note: Please refer to "Technical specifica-
tions" for the power connection specifica-
tions of the power tools.
Illustration
 Adjust the tool adapter to fit the connec-
tion of the electric power tool.
Illustration
 Remove the elbow from the suction
hose.
 Attach the tool adapter to the suction
hose.
Illustration
 Connect the tool adapter to the electric
power tool.
Emptying the dirt container
CAUTION
Please observe the local provisions regard-
ing the wastewater treatment.
– The vacuum channel is equipped with a
float.
– When the dirt water reaches the highest
permissible level in the container, the
suction power is interrupted.
 Switch off the appliance at the main
switch.
Illustration
 Drain off dirty water through the drain-
age hose.
Turn off the appliance
 Switch off the appliance at the main
switch.
 Pull out the mains plug.
After each operation
 Empty the dirt container.
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
Storing the Appliance
Illustration
 Store the suction pipes, the suction
hose and the mains cable as shown in
the illustration.
 Place the appliance in a dry room and
secure it from unauthorized use.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
Illustration
 Transport the appliance as shown in the
illustration.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Care and maintenance

DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
Change cartridge filter
 Release and remove the suction head.
 Turn the suction basket by 180° and
keep it aside.
 Loosen the mounting nuts
 Remove the cartridge filter.
 Insert the new cartridge filter.
 Insert the fastening nut and tighten it.
 Insert and lock the suction head.

Troubleshooting

DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
Suction turbine does not run
 Check the receptacle and the fuse of
the power supply.
 Check the power cable, mains plug and
socket of the appliance.
 Turn on the appliance.
– 3
EN

Transport

Storage

15