Conrad VC333 Bedienungsanleitung Seite 12

Operating Measurement
mode range
DC voltage- 200 mV
2 V
20 V
200 V
600 V
AC voltage 200 V
600 V
DC current 2000 uA
20 mA
200 mA
10 A
10 A
Resistance 200 Ohm
2 kOhm
20 kOhm
200 kOhm
20 MOhm
Measurement voltage at open circuit being measured : < 3 V
Temperature -40 b +1200°C
Stated tolerance applies up to 150°C
Diode test Test current: 1,0 mA max.
Test voltage:3 VDC max.
Continuity test : Acoustic signal with resistances
< approx. 70 Ohm ±20 Ohm
Transistor test range ..............: hFE 0 - 1000
Base current...........................: approx. 10 uA
Vce (Uce)................................: max. 3 V
22
Accuracy Resolution
±(0.5%+2dgts) 100 uV
———"——— 1mV
———"——— 10 mV
———"——— 100 mV
±(0.8%+2dgts) 1 V
±(1.2%+10dgts) 100 mV
±(1.2%+10dgts) 1 V
±(1.0%+2dgts) 1 uA
±(1.0%+2dgts) 10uA
±(1.2%+2dgts) 100 uA
±(2.0%+5dgts) 10 mA
10 s period max.
±(0.8%+5dgts) 0,1 Ohm
±(0.8%+2dgts) 1 Ohm
±(0.8%+2dgts) 10 Ohm
±(0.8%+2dgts) 100 Ohm
±(1.0%+5dgts) 10 kOhm
±(1.0%+3dgts) 1°C
Maximum input quantities, overload protection
Voltage measurement .............: 600 VDC / AC rms max., electrically
Current measurement .............: 10 A DC in A range, unfused, 10 s
Resistance measurement .......: 20 MOhm, overload protection :
The transistor test and diode test measurement
functions are not protected against overload or too
high an input voltage.
Exceeding the maximum permissible input level can
lead under unfavourable circumstances to damage
to the measuring instrument or to the life of the
user becoming endangered.
isolated from AC mains, overvolta-
ge category I (CAT 1). In overvolta-
ge category II (CAT II) measure-
ments up to 300 VDC / AC rms
max.
duration max. with subsequent
cooling phase of at least 15 min.,
35 VDC max.
200mA AC/DC max. in mA-range,
max. 35 VDC
Overload protection: 0.3A 250V
quick-blow fuse (dimensions: 5 x
20 mm)
250 VDC/AC
23