Assembly; Scope Of Delivery; Transport; The Workplace - Zipper ZI-RTS700 Originalbetriebsanleitung

The operation of the machine without the proposed protective devices is not permitted, the
dismantling of the protective devices is prohibited.
The operation of the machine on uneven and / or slippery surfaces is strictly PROHIBITED!
It is not permitted any further way of business who is not compliant in one or more points with
the safety rules and other operating and maintenance instructions in this manual.
For a different or additional use and resulting property damage or injury ZIPPER
MACHINES assumes no responsibility or warranty.
13

ASSEMBLY

13.1 Scope of delivery

Unpack it from the ZIPPER Roll table saw ZI-RMM94H and check the machine is in good condition
and completeness of the supply of the following parts:
1x Roll table saw ZI-RTS700, 1x carry handle, 1x hard-metal blade, 1x Instruction Manual

13.2 Transport

The rolling table saw can be transported through the attached chassis. At the rear of a carrying
handle is attached. It can be pulled out. By lifting the saw with the carrying handle, the saw can
be easily transported.
The transport of the machine may only be made using the transit bar. The machine must not be
raised at the table.
Caution: If the carrying handle is not required, it must be pushed to the base frame.

13.3 The workplace

Choose a suitable place for the machine. This shall conform to applicable provisions for job securi-
ty and have a suitable power and compressed air supply.
The ground must be firm and level and can support the weight of the machine.
Provide at least 1m free space around the machine.
The operation is only allowed outdoors.
The operation is prohibited in fire or explosive environments.
The operation of the machine when humidity is above 70 ° is prohibited
IMPORTANT NOTE SAW BLADE BRAKE:
If after turning off the machine, the blade is not in max. 10 seconds. comes to a standstill,
the saw must not be operated because the brake is possibly defective. The machine must be dis-
connected from the power supply. Please leave check the machine by a licensed electrician,
whether the restriction contained in the switch fuses are defective and must be replaced.
Upon failure of the braking function of the saw blade, the use of the saw is
generally prohibited!
Z.I.P.P.E.R Maschinen Austria www.Zipper-maschinen.at
A T T E N T I O N
ASSEMBLY
Rolltischsäge / Roll table saw ZI-RTS700
Seite23