Residual Risks; Notes On The Nature Of The Work Pieces; Improper Use - Zipper ZI-RTS700 Originalbetriebsanleitung

Do not allow children to operate the machine, and no person who has not read these instruc-
tions or is not familiar with the Roll table saw.
The user is responsible for working with the Roll table saw for third parties.
Use the Roll table saw only for the intended purpose. Be careful when cleaning the Roll table
saw or maintenance work.
It is forbidden to bring any electrical and mechanical safety devices elsewhere or to change .
Replace your safety, all worn or damaged parts.
Use only original spare parts. Parts that were not made by the manufacturer could sit bad and
may cause injury.
Store it in a dry and safe place out of reach of children.
Use only three-wire earthed extension cord.
Use only approved for outdoor use extension cord, and check before use if they are in good
condition.
Protect against any damage due to excessive mechanical stress, sharp edges, moving parts
and contact with corrosive liquids, etc., the cable.
Attention! Do not use an extension cord, which shows signs of damage. Connect a completely
new cable and remove any permanent or temporary repairs. Let's replace the cable from a
qualified professional.
Before inserting the plug into the mains socket, make sure that the mains voltage corresponds
to the specifications on the nameplate of the harvester.
Turn the Roll table saw off before disconnecting any plug or extension cord.

12.3 Residual risks

Also in compliance with all safety regulations and when used properly, the following residual
risks must be observed:
By adhering to all safety regulations such hazards can be reduced to a minimum!
Risk of injury to the hands / fingers through the rotating saw blade during operation.
Risk of injury due to breakage or being thrown out of the circular saw blade and circular saw
blade parts, especially in case of overload.
Hearing damage unless precautions have been taken by the user of hearing protection.
Risk of injury from kickback of the cut material, ejecting the cut material or portions thereof.
Risk of injury to the eye by flying debris, even with goggles.
Risk of inhalation of toxic wood dust in treated workpieces.

12.3.1 Notes on the nature of the work pieces

No foreign objects, such as nails in the wood may be located.
There may only one cut, regardless of its dimensions will be processed! It may not be pro-
cessed and no more bundles of clippings.
Curved cut is to insert into the feed tray, that the outer edge of the bend for circular saw is to
reduce wedging and check the cut material.

12.3.2 Improper use

The machine is not designed for operation in explosion-hazardous conditions.
Z.I.P.P.E.R Maschinen Austria www.Zipper-maschinen.at
SAFETY
Rolltischsäge / Roll table saw ZI-RTS700
Seite22