Fagor 2LF 013 IX Installationsanleitung Und Bedienungsanleitung Seite 58

4
PANEL-MOUNTING AND RECESS-MOUNTING
PANELLING
Simply fit the same decor panels or doors as the kitchen cupboards to the dishwasher
door. Said panels must be more than 4 mm thick.
Remove the frame around
a
the door by unfastening the
screws.
b Cut the panel to size: 596 x
586 mm.
c Fit the decor panel or door
To fasten the new decorative
panel in place, screw the
frame back onto the door.
With models fitted, the
height to which the door
can be panelled can be
adjusted to the same height
as the kitchen cupboards.
Remove the frame around
a
the door by unfastening the
screws.
Remove the decor panel
b
from the dishwasher.
Adjust the plate at the
c
bottom of the dishwasher
door to the height of the
kitchen cupboards.
d Place the decor panel on the
frame and cut it to the same
height as the decor panel.
e Place the panel on the door,
hold the frame in place and
mark the position of the new
holes on the door. Drill the
holes with a 3.25 mm
diameter bit (be careful not
to drill too deep) and screw
the frame into place.
a
c
b
d
b
a
c
e