Acoustic Signals - Atag VA63211LT Benutzerinformation

How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
the indicators
and start to flash.
2. Press .
• The indicators
and go off.
• The indicator
• The end indicator starts to flash. The
number of flashes indicates the
current setting: e.g. 4 flashes +
pause + 4 flashes = level 4.
– The levels of rinse aid are from 0
to 6.
– Level 0 = no rinse aid is
released. In this case the end
indicator remains off.
3. Press again and again to change the
setting. Each time you press
level increases. After level 6 you go to
level 0 and then start again from level 1.
4. Press the on/off button to confirm the
setting.
Use of rinse aid and multi-
tablets
The factory setting of the rinse aid
dispenser is with the dispenser activated.
This means that the rinse aid dispenser
always releases rinse aid.
It is possible to deactivate the rinse aid
dispenser, in this case the dispenser will not
release rinse aid only if the option Multitab
is activated.
If the dispenser is deactivated and you do
not select the option Multitab, the dispenser
will release rinse aid.
The use of the option Multitab with the rinse
aid dispenser deactivated may not give
satisfying drying results.
and until
, ,
,
continues to flash.
the
When the rinse aid dispenser is
deactivated, the rinse aid indicator is always
off when the option Multitab is activated.
How to deactivate the rinse aid
dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
the indicators
and start to flash.
2. Press
• The indicators
go off.
• The indicator
to flash.
• The end indicator indicates the
current setting: End indicator on =
the rinse aid dispenser is activated
(factory setting).
3. Press
End indicator off = the rinse aid dispenser is
deactivated.
4. Press the on/off button to confirm the
setting.

Acoustic signals

Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
There is also an acoustic signal that sounds
when the programme is completed. By
default this acoustic signal is deactivated
but it is possible to activate it.
How to activate the acoustic
signal for the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
and until
, ,
.
, and
continues
to change the setting.
and until
9