Options; Before First Use - Atag VA63211LT Benutzerinformation

10
the indicators
and start to flash.
2. Press
• The indicators
and go off.
• The indicator

OPTIONS

Desired options must be
activated every time before you
start a programme.
It is not possible to activate or
deactivate options while a
programme is running.
Multitab
Activate this option when you use multi-
tablets that integrate the salt, rinse aid and
detergent functions. They can also contain
other cleaning or rinsing agents.
This option deactivates the release of salt.
The salt indicator does not come on.
This option also deactivates the release of
rinse aid but only when the rinse aid

BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the baskets.
When you start a programme, the
appliance can take up to 5 minutes to
recharge the resin in the water softener. It
seems that the appliance is not working.
The washing phase starts only after this
procedure is completed. The procedure will
be repeated periodically.
, ,
,
continues to flash.
• The end indicator indicates the
current setting: End indicator off =
Acoustic signal off.
3. Press to change the setting.
End indicator on = Acoustic signal on.
4. Press the on/off button to confirm the
setting.
dispenser is deactivated, (rinse aid indicator
does not come on). If the rinse aid
dispenser is activated, rinse aid is released
even with the option Multitab activated.
With the use of this option the programme
duration is prolonged to increase the
cleaning and drying results with the use of
multi-tablets.
Multitab is not a permanent option and
must be selected at every cycle.
How to activate Multitab
Press and hold simultaneously
until the indicator
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt container
(Only for the first time).
3. Fill the salt container with dishwasher
salt.
and
comes on.