Acoustic Signals - Atag VA55312BT Benutzerinformation

Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
until the indicators
and start flashing and the
display is blank.
2. Press .
• The indicators
are off.
• The indicator
flash.
• The display shows the current
setting: e.g.
– The levels of rinse aid range
from 0A to 6A where level 0A
means rinse aid is not used.
3. Press repeatedly to change the
setting.
4. Press on/off to confirm the setting.
The rinse aid empty notification
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying to
refill rinse aid. If the drying results are
satisfactory while using multi-tablets only,
it is possible to deactivate the notification
for refilling rinse aid. However, for best
drying performance, always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
and
, , ,
, , and
continues to
= level 4.
How to deactivate the rinse aid
empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
until the indicators
and start flashing and the
display is blank.
2. Press .
• The indicators
are off.
• The indicator
• The display shows the current
setting:
notification is activated (factory
setting).
3. Press to change the setting.
= the rinse aid empty notification is
deactivated.
4. Press on/off to confirm the setting.

Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to activate
it.
How to activate the acoustic
signal for the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and hold
simultaneously
the indicators
and flash and the display is blank.
2. Press
and
, ,
, , and
still flashes.
= the rinse aid empty
and until
, , ,
9
,