Werbung
Verfügbare Sprachen
Verfügbare Sprachen
30. Be careful when handling the jug as the blades are very sharp. Be careful when
emptying the blender jug and during cleaning. Mishandling of the blades may
cause injury.
Do not remove the blender jug from the motor base while in operation or not
switched off.
31. Do not use the SOLIS Perfect Blender Pro for anything other than food and/or
beverage preparation.
32. Do not operate the blender without food or liquid in the blender jug.
33. Do not process hot or boiling liquids. Allow to cool before placing into the
blender jug.
34. So not subject the blender jug to extremes of hot or cold, for example, placing
a cold jug in hot water or vice versa.
35. Keep the appliance clean. Refer to „Care and cleaning" instructions in this manual.
„OVERLOAD PROTECTION" is flashing.
Once the blender motor of your SOLIS Perfect Blender Pro is overloaded, the motor
will switch off automatically and the warning icon „OVERLOAD PROTECTION" is
flashing on the display. As soon as the blender motor has cooled down, the icon
will stop flashing and you will be able to use the blender as per instructions. At this
point the blender will be in standby mode and you will only need to press the but-
ton that you require to start blending again. However if you have turned the
blender off with the button „POWER" you will need to switch it back on with the
button „POWER"
usual.
Warning:
Do not operate the appliance continuously with heavy loads for more than
10 seconds.
70
Warning:
Please do not attempt to use the blender while the
. Only if the icon has stop flashing commence blending as
Werbung
