Dispensing Of Hot Water; Dispensing Of Steam - ECM Elektronika Profi Due Bedienungsanleitung

Make sure that the filter is clamped firmly into the filter holder.
Do not overfill the measuring-spoon, as shown in the figure below!
3 Clamp the filter holder firmly into the brew group.
4 Place the cup under the spout of the filter holder. (For the preparation of 2 cups, put 1 cup under each spout.)
5 Press the button with the programmed dose of coffee you would like to consume. As soon as the programmed
dose is reached, the filling stops automatically.
• Only freshly ground coffee allows for an optimal coffee result. Therefore, use a professional coffee
grinder. In our assortment you will find several professional and compact coffee grinders.
• We recommend to use a stainless steel tamper with a diameter of 58 mm for optimum tamping.

6.3 Dispensing of hot water

1 Place an adequate water container (with a heat-insulated handle) under the hot water dispenser. After having
moved the power switch into the lower position, you can dispense water (e. g. for tea) by opening the hot water
lever.
2 After dispensing water, switch the machine on again. The boiler will be filled with fresh water automatically.
When the machine is switched off, more hot water can be dispensed.
However, one does not necessarily have to switch off the machine for dispensing hot water.
Caution!
Place the nozzle of the dispenser into the water container in order to avoid injuries due to hot water
spillings.

6.4 Dispensing of steam

The ELEKTRONIKA PROFI DUE makes it possible to generate large amounts of steam in order to heat or froth
beverages, e. g. milk or punch. It is a professional and compact espresso coffee machine with an enormous steam
volume. Therfore, within a few seconds you can prepare milk froth. Please pay attention to the instructions below.
Do not bring the milk to a boil, otherwise frothing milk will not be possible.
1 Important: In order to get the best result when frothing milk, open the steam lever for approx. 5 seconds to
release the condensation water in the pipe.
2 Immerse the steam nozzle (at the end of the steam dispenser) in the liquid.
3 Re-open the steam handle / steam lever.
4 Heat and/or froth the liquid.
5 After frothing or heating, release the steam into the drip tray to keep the holes of the steam nozzle clean.
Risk of injury
Always keep the steam nozzle underneath the surface of the liquid while heating or frothing in order
to avoid sprayings.
Important
After every application clean the steam nozzle and the steam dispenser with a non-abrasive, damp
cloth. this removes possible liquid residues.
Risk of injury
Avoid skin contact with the steam dispenser while cleaning!
Instruction manual ELEKTRONIKA PROFI DUE
26
ENGLISH