Trigger; Filling Cap; Release Button; Rear Support Hook - Fakir RAPHAEL PLUS Bedienungsanleitung

BEFORE USE
GB

Trigger

Grasp the water tank's handle with the hand and press the trigger with one finger, then
you can take out of the water tank for filling water.

Filling cap

The filling cap is attached in the water tank, if less water in the tank, you shall open the
cap and fill water. After filling water, close it.

Release button

Press the release button with one finger and grasp the iron's handle with the hand, and
then you can slide out the iron anti-clockwise.

Rear support hook

When you need to replace the iron onto the thermal insulating cushion, you can firstly
insert the back of the iron into the rear support hook, then put the soleplate on the
locking pin and press the locking pin down, and then you can rotate the iron clockwise
until the iron is fixed into the front support hook. At this time, the iron can be secured
onto the thermal insulating cushion.

Front support hook

You can put the iron on the front support hook for operation, and you can also secure
the iron into the front support hook after finishing ironing.

ON/OFF switch

Plug in the appliance and press down the ON/OFF switch, a "D" sound of buzzer will be
heard and the power indicator will be illuminated, also the low steam rate regarded as
defaulted one and its indicator will flash. Press down the ON/OFF switch for 2 seconds,
together with a "D" sound of buzzer, both the power indicator and steam indicator will
be extinguished, and the appliance will be disconnected from the power supply.

Temperature dial

Turn the dial to set ironing temperature to meet the garment changed.

Temperature indicator

When the iron is heating up, the temperature indicator will be illuminated. Once the iron
has reached the selected temperature, it will extinguish. The temperature indicator will
be cycled on and off as the iron maintains the selected temperature during ironing.
21