Zanussi ZOS 35802 Benutzerinformation Seite 7

Steam Cooking
1. Set the function
2. Press the cover of the water drawer to
open it. Fill the water drawer with water un-
til the Tank Full indicator comes on. The
maximum capacity of the tank is 900 ml. It
is sufficient for approximately 55 - 60 mi-
nutes of cooking.
Important! Do not put water directly into the
steam generator.
Use only water as the liquid. Do not use filtered
(demineralised) or distilled water. Do not use
other liquids.
Do not put flammable or alcoholic liquids
(grappa, whisky, cognac, etc.) into the water
drawer.
3. Push the water drawer into its initial posi-
tion.
4. Prepare the food in the correct cookware.
5. Set the temperature between 130 °C and
250 °C. Refer to table for steam cooking.
6. Empty the water tank after the steam cook-
ing is completed.
Warning! Wait a minimum of 60 minutes
after each use of the True Fan + Steam
function in order to prevent hot water from
exiting the water outlet valve.
Tank Empty indicator
The indicator shows that the tank is empty and
must be refilled.
For more information refer to "Steam Cooking".
Tank Full indicator
The indicator shows that the oven is prepared
for steam cooking.
www.zanussi.com
.
If you put too much water into the
tank, the safety outlet moves the ex-
cess water to the bottom of the oven.
Remove the water with a sponge or cloth.
Emptying the water tank
Important! Make sure that the appliance is
cool before you start to empty the water tank.
1. Prepare the draining pipe (C), included in
the same package with the user manual.
Put the connector (B) onto one of the ends
of the draining pipe.
A
B
C
2. Put the second end of the draining pipe
(C) into a container. Put it at a lower posi-
tion than the outlet valve (A).
3. Open the oven door and put the connector
(B) into the outlet valve (A).
4. Push the connector again and again when
you empty the water tank.
5. Remove the connector from the valve when
the water stops flowing.
Warning! Do not use the drained water to
fill the water tank again.
The tank can have some water when the
Tank Empty indicator
the water flow from the water outlet valve stops.
is on. Wait until
7