Kärcher BR 40/25 C Bp Handbuch Seite 24

Battery control display
The battery control display shows the
charging status of the batteries when the
charger has been connected:
40-100% glows green
20-40% glows yellow
0-20% slowly blinks red
empty glows red
Note
The appliance is switched off automatically if
the battery has been fully discharged (battery
indicator glows red). You can restart the appli-
ance only after you have fully charged the bat-
tery.
Spare batteries
You can acquire additional sets of batteries
to avoid the waiting time when the batteries
are getting charged. You can then replace
the empty battery set in the appliance by a
charged set of batteries.
Note
The spare battery set must show a mini-
mum voltage of 25.8 V when you connect it
to the appliance. If the voltage is lower, the
electronic mechanism to prevent total dis-
charge will block the appliance startup. In
such a case you would need to fully charge
the battery.
Setting the Vacuum Bar
Oblique position
To improve the vacuuming result on tiled
floors the vacuum bar can be turned to an
oblique position of up to 5°.
 Release the wing nuts.
 Turn the vacuum bar.
 Tighten the wing nuts.
24
Inclination
If the vacuum result is unsatisfactory the in-
clination of the straight vacuum bar can be
modified.
 Release the wing nuts.
 Tilt the vacuum bar.
 Tighten the wing nuts.
Setting the advance speed (BD
 Turn the running gear to the front with
your foot.
 Reducing the speed: Turn the wheel in
– direction.
 Increasing the speed: Turn the wheel in
+ direction.
– 8
EN
model only)