Level Adjustment - ELAC 4 PI PLUS.2 Bedienungsanleitung

Level adjustment

The sensitivity of the ELAC 4 PI PLUS.2 can be adjusted by means of the selector switch (1). The sensitivity should be
"0" when used with main speakers that provide approx. 88 dB/2.8V/m.
If the values of your loudspeakers are below this, (and to decrease the effect of the ELAC 4 PI PLUS.2), the selector
switch (1) can be adjusted in the appropriate way (-2 dB or -4 dB) in order to reduce the levels. If the sound of the 4 PI
PLUS.2 is too low at „0", compared to the sound of the main speakers, the level can be increased (+2 dB oder +4 dB)
by adjusting the selector switch (1). The best result will be determined by listening.
Bi-amping
A second stereo amplifier (starting with 2 x 20 W) with adjusters for levels and volume enables the individual adjust-
ment of the 4 PI PLUS.2 according to your demands. It also enables the perfect adjustment with main speakers that
provide a sensitivity of 92 dB/2.8V/m.
The volume should not be too loud for presetting.
Page 9 von 12