Usb Playback; Error Displays/Messages - Sony CDX-GT929U Bedienungsanleitung

USB playback

You cannot play back items via a USB HUB.
This unit cannot recognize USB devices via a USB
HUB.
Cannot play back items.
A USB does not work.
t Reconnect it.
A beep sounds.
During playback, the USB device has been
disconnected.
t Before disconnecting a USB device, make sure to
stop playback first for data protection.
The sound is intermittent.
The sound may be intermittent at a high-bit-rate of
more than 320 kbps.

Error displays/Messages

Blank Disc
Tracks have not been recorded on the MD.
t Play an MD with recorded tracks.
Checking
The unit is confirming the connection of a USB device.
t Wait until confirming the connection is finished.
2
Error*
• The disc is dirty or inserted upside down.
t Clean or insert the disc correctly.
• A blank disc has been inserted.
• The disc cannot play because of some problem.
t Insert another disc.
• USB device was not automatically recognized.
t Reconnect it again.
• Press Z to remove the disc.
Failure
The connection of speakers/amplifiers is incorrect.
t See the installation guide manual of this model to
check the connection.
Hubs Not Supported
USB HUB is not supported on this unit.
Load
The changer is loading the disc.
t Wait until loading is complete.
Local Seek +/–
The local seek mode is on during automatic tuning.
NO AF
There is no alternative frequency for the current
station.
t Push the multi way encoder left/right while the
program service name is flashing. The unit starts
searching for another frequency with the same PI
(Program Identification) data ("PI SEEK" appears).
NO Album Name
An album name is not written in the track.
NO Artist Name
An artist name is not written in the track.
NO Device
(SOURCE) is selected without a USB device
connected. A USB device or a USB cable has been
disconnected during playback.
t Be sure to connect a USB device and USB cable.
NO Disc
The disc is not inserted in the CD/MD changer.
t Insert discs in the changer.
NO Disc Name
A disc/album/group/track name is not written in the
track.
NO ID3 Tag*
ID3 tag information is not written in the MP3 file.
NO Magazine
The disc magazine is not inserted in the CD changer.
t Insert the magazine in the changer.
NO Music
The disc/USB device does not contain a music file.
t Insert a music CD in this unit or MP3 playable
changer.
1
* t Connect a USB device with a music file in it.
Not Read
The disc information has not been read by the unit.
t Load the disc, then select it on the list.
Not Ready
The lid of the MD changer is open or the MDs are not
1
* inserted properly.
t Close the lid or insert the MDs properly.
Not Supported
The connected USB device is not supported.
t Connect a USB device of Mass Storage Class
(page 24).
NO TP
The unit will continue searching for available TP
stations.
NO Track
The selected item in the USB device does not contain
an album/track.
NO Track Name
A track name is not written in the track.
Offset
There may be an internal malfunction.
t Check the connection. If the error indication
remains on in the display, consult your nearest
Sony dealer.
Overload
USB device is overloaded.
t Disconnect the USB device, then change the source
by pressing (SOURCE).
t Indicates that the USB device is out of order, or an
unsupported device is connected.
Read
The unit is reading all track and album/group
information on the disc/USB device.
t Wait until reading is complete and playback starts
automatically. Depending on the disc/USB device
structure, it may take more than a minute.
3
continue to next page t
29