Replacing The Active Airclean 30 And Hepa Airclean 30 Exhaust Filters; Replacing One Type Of Exhaust Filter With Another; When Changing The Filter, Please Note; How To Remove Threads And Hair From The Electrobrush - Miele Dynamic U1 Gebrauchsanweisung

 Open the filter grille and remove the
used AirClean filter by one of the
clean, unsoiled sections.
 Replace it with a new AirClean filter.
If you wish to fit an Active
AirClean 30 or a HEPA AirClean 30,
see "Maintenance - Replacing one
type of exhaust filter with another".
 Secure the catch on the filter grille
and replace it inside the exhaust filter
compartment.
 Close the exhaust filter compartment
lid.
Replacing the Active AirClean 30 and
HEPA AirClean 30 exhaust filters
(dia. 29)
Do not use more than one exhaust fil-
ter at a time.
 Open the exhaust filter compartment
lid.
 Remove the exhaust filter.
 Insert the new exhaust filter and
press the exhaust filter timestrip®
change indicator (dia. 05).
After approx. 10 - 15 seconds, a thin
red line will appear in the left hand side
of the display (dia. 06).
If you wish to fit an AirClean filter,
see "Maintenance - Replacing one
type of exhaust filter with another".
 Close the exhaust filter compartment
lid.
Replacing one type of exhaust filter
with another (dia. 02)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean
b Active AirClean 30 (black)
c HEPA AirClean 30 (white)
Do not use more than one exhaust fil-
ter at a time.

When changing the filter, please note

1. If you wish to replace exhaust filter a
with filter b or c, it is essential that
you remove the filter grille before you
fit the new exhaust filter.
You must also activate the exhaust
filter timestrip® change indicator
(dia. 05).
2. If you wish to replace exhaust filter b
or c with filter a, you must insert the
new filter into a filter grille * before in-
stalling (dia. 27).
* Filter grille - see "Optional ac-
cessories"
How to remove threads and hair from
the Electrobrush
 Switch the Electrobrush and the va-
cuum cleaner off, switch off at the
wall socket and remove the plug.
 Release the vacuum cleaner (dia. 11)
and place it flat on the floor.
 Turn the vacuum cleaner over.
en
43