When To Change The Motor Protection Filter; How To Change The Dust Compartment Filter; When To Replace The Exhaust Filter; How To Replace The Airclean Exhaust Filter - Miele Dynamic U1 Gebrauchsanweisung

en
The dustbag has a closing flap which
closes automatically when the dust
compartment lid is raised to prevent
any dust escaping.
 Fit the new dustbag into the holder as
far as it will go. Leave it folded up
when you take it out of the box.
 It should be unfolded as far as pos-
sible in the dust compartment.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so. The dustbag is
then automatically guided into posi-
tion for vacuuming.

The lid will not close without a
dustbag in place. Do not force it!
When to change the motor protection
filter
Replace this filter every time you start a
new packet of dustbags.
Every packet of original Miele dustbags
contains a motor protection filter. Mul-
tipacks contain four motor protection
filters (only available in selected coun-
tries).
How to change the dust compart-
ment filter (dia. 25)
 Open the dust compartment lid.
 Remove the dustbag.
 Unclip the filter frame in the dust
compartment and remove the old fil-
ter. Hold by the clean, unsoiled sec-
tion to remove it.
 Replace with a new dust compart-
ment filter.
42
 Close the filter frame.
 Fit the dustbag into the holder as far
as it will go.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.

When to replace the exhaust filter

Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
02).
a AirClean
Replace this filter every time you start a
new packet of dustbags. Every packet
of original Miele dustbags contains one
AirClean exhaust filter. Multipacks con-
tain four AirClean filters.
b Active AirClean 30 (black)
c HEPA AirClean 30 (white)
Replace this filter when the exhaust fil-
ter timestrip® change indicator is com-
pletely red (dia. 07). The indicator lights
up after approximately 50 hours of op-
eration, which is equivalent to about a
year of average use. You can continue
vacuuming when the light comes on.
However, the suction power will be re-
duced as will the effectiveness of the fil-
ter if it is not replaced in good time.
How to replace the AirClean exhaust
filter (dia. 26, 27 + 28)
Do not use more than one exhaust fil-
ter at a time.
 Open the exhaust filter compartment
lid.
 Remove the filter grille.