IKEA FÖLJANDE 10392192 Bedienungsanleitung Seite 6

ENGLISH
• Before touching the light bulbs,
ensure that they are cold.
• Do not use or leave the hood
without the light bulb correctly
fitted, as this may cause electric
shock.
• The hood is not a work surface,
therefore do not place any
objects on top of it or overload
it.
• During all installation and
maintenance operations wear
appropriate working gloves.
• This appliance is not suitable
for outdoor use.
WARNING: when the hob is in
use, accessible parts of the
hood may become hot.
Installation and connection
In the event of problems, contact
the Authorized Service Centre. To
prevent any damage, only remove
the appliance from its packaging
at the time of installation.
Preparing for installation
WARNING: this is a heavy
product; the hood should only
be lifted and installed by two or
more people.
The minimum distance between
the hob and the bottom part of
the hood must not be less than 65
cm for burning gas or other fuels
and 50cm for electric cookers.
Before installation also check the
minimum distances stated in the
manual of the cooker.
If the installation instructions
for the cooker specify a greater
distance between cooker and
hood, this distance must be
observed.
Electrical connection
Make sure the power voltage
specified on the appliance rating
plate is the same as the mains
voltage.
This information can be found
on the inside of the hood, under
the grease filter. Power cable
replacement (type H05 VV-F)
must be carried out by a qualified
electrician. Contact an authorized
service centre.
If the hood is fitted with an electric
plug, connect the plug to a socket
complying with current regulations,
located in an accessible place.
WARNING: if no plug is fitted
(direct wiring to the mains), or
if the socket is not located in an
accessible place, a qualified
electrician should install a
standardised double pole power
switch that will enable complete
isolation from the mains in case of
category III overvoltage
conditions, in accordance with
wiring rules.
6