Continuity Test; Diode Testing; Capacity Measurement - PANCONTROL PAN 111 Bedienungsanleitung

Continuity test

Attention: Before making any measurements, make sure the circuit is
disconnected from any power source and all capacitors are properly
discharged!
Set the rotary switch to the 
1.
2. Press the SELECT button to select the desired function.
3. Connect the test prods of the leads to the resistance or circuit to be
tested. To avoid influence disconnect the resistant to be tested from the
circuit.
4. If the resistance is less than about 60 Ω, you hear an audible signal. If the
circuit is open, the display shows "OL" or "1".

Diode testing

Set the rotary switch to the 
1.
2. Press the SELECT button to select the desired function.
3. Touch the diode to be tested with the probes. The forward voltage shows
400 to 700mV. The counter voltage shows „OL" or "1". Defective devices
show a value about 0 mV or „OL" or "1" in both polarities.

Capacity measurement

Set the rotary switch to the 
1.
2. Press the SELECT button to select the desired function.
3. For capacitors with known polarity connect the red test lead with the
anode and the black test lead with the cathode. Once the reading
stabilizes, read the value. Use the HOLD function if the reading is difficult
to read.
- Position
- Position
- Position
EN 11