Maintenance - Wolf Garten GT 830 Originalbetriebsanleitung

Working position
The optimal operational gradient for edging and
free-cutting is approx. 30°. For free cutting (no
ground contact) swing device in a semicircle be-
fore your body.
Vertical edge-trimming
Teh machine can be adjusted for vertical
trimming. Grip machine firmly. Pull tube
and turn 180° until it audibly engages
On / off switch

Maintenance

Replacing the cord spool
1
The trimmer continues to spin after
being switched off! Always disconnect
from the power supply before perform-
ing any work on the trimmer!
1. Hold spool case, turn cover in „AUF" (open) di-
rection of the arrow and remove it, remove
empty thread cartridge
2. Insert the thread end of the new thread cart-
ridge through the thread lug
loosen the thread from the retainingslot of the
thread cartridge
3. Slide thread cartridge over the metal knob.
Pull end of thread until the thread is loosened
from the retaining slot of the thread cartridge
K
. Ensure correct position of the thread
from the thread cartridge to the thread lug.
4. Attach cover. One of the two arrow markings
should point towards the thread lug. Press
down on cover and turn to the right until it cat-
L
ches audibly
1
When switched on, thread is cut off to
operational length. Only switch machine
on when in operational position.
14
C
D E
D
F
H
.
J
(1). Do not
J
(2).
(1) +(2).
Thread adjustment
The thread is adjusted with the tilt switch. Briefly tilt
the running machine on a firm base, e. g. paving
slab (approx. 3 kg pressure). Approx. 2,5 cm cut-
ting thread are the automatically paid out.
3
Tips on trimming
z Cut high grass slowly, step by step.
z Move trimming head only as close to tree
z Trimming too closely along walls or con-
.
z You can prolong the life of your trimmer
G
trunks and bushes as necessary.
crete slabs wears out line unnecessarily.
by removing grass from the ventilation
slots and the bottom of the trimmer be-
fore or after each use.
G