Operation; Operating Times - Wolf Garten GT 830 Originalbetriebsanleitung

z Always wear appropriate working clothes and
sound footwear when using the trimmer.
z Before carrying the trimmer to the next lawn
area to be cut, switch it off.
z Be careful when you go backwards. You may
stumble!
z Keep the cable away from the cutting tool.
z Should the powercord be damaged during
use, immediately disconnect it from the mains.
Do not touch the cable until it has been discon-
nected from the mains.
z Never leave the trimmer without supervision.
Store it in a safe place.
z The switches installed shall not be removed or
bridged over, e. g. by binding the switch to the
handle.
z Do not allow the cord spool to strike the ground
or edges of working area. If the cord spool re-
ceives a hard knock, this will cause a strong vi-
bration on the handle. If this occurs, the
trimmer should be checked by a qualified ser-
vice centre.
After operating
z After using the unit, disconnected the power
cord from the wall outlet and inspect the unit
for damage.

Operation

Operating times

z Please check noise abatement regulations
prevailing in your country.
How to adjust the central handle
The auxiliary handle can be adjusted sideways
and vertically by lossening the knob. Recommen-
dation.
Insert power cable into cable holder
The power cable holder in the guide grip prevents
accidental disconnection of the extension cable.
G
z When switching off the trimmer: Attention: the
cutting tool does not stop immediately!
z Always wait for the cutting tool is stop.
z Before examining or cleaning the tool or be-
fore removing the safety device or the cord
spool, switch off and disconnect the trimmer
from the mains. Only use original WOLF-Gar-
ten cord spools and note the installation ins-
tructions!
z The cutting knife should not be cleaned under
running water or under high-pressure.
z Faults shall only be repaired by appointed ser-
vice centres or by the manufacturer.
z Make sure all air holes are free of dirt.
z Do not store the unit within reach of children.
Disposal
Connect to the socket (230 Volt, 50 Hz)
z Connect the device only to sockets that are
protected with a 10-16 Amp. fuse (or LS switch
type B)
3
Note: Residual current protection device
A
These safeguards provide protection against
severe injuries resulting from touching dam-
aged cables, insulation defects and in some
cases cables that conduct electricity.
z We recommend that the equipment only be
B
plugged into a power socket, which is protect-
ed by a residual current protection device
(RCD) with a residual current of no more than
30 mA.
z Retrofit kits are available for old installations.
Consult an electrician
Do not dispose of electrical equip-
ment in domestic waste. Recycle
equip-ment, accessories and packa-
ging in an environment-friendly man-
ner.
13