Assembly; Operation - Wolf Garten HBM Power 64 BA Originalbetriebsanleitung

z For safety reasons replace worn out or damaged parts.
z NOTE! Always have blades replaced or sharpened by a
WOLF-Garten Service Centre, as a blade balance test must
be performed in accordance with safety regulations and the
blade retaining bolt must be tightened to a specified torque.

Assembly

Fixing of handle
A
1
ATTENTION! Take care that the switch cable does not
become caught and crused when folding the handle
frame.
Fasten the handle bar as in the illustration.

Operation

Operating times
z Please check noise abatement regulations prevailing in your
country.
Starter cord assembly
1. Lift and hold operator presence bail arm
2. Pull the starter rope slowly to the holding bracket.
3.
Twist the cord through the holder
3
Always remove the starter cord from the holder before
folding the mower handles.
Oil Fill
K
1
Check oil level with mower standing on level ground.
Fill crankcase with quality oil SAE 30 up to the mark „Full"
on dipstick. (Do not overfill.) Capacity approx. 0,6 litre.
Screw in dipstick according to illus.
Filling with fuel
1
Caution! Rotating blades
Settings only to be carried out on the machine with the mo-
tor switched off and with the working tools at a standstill.
z Use only normal lead-free petrol (not Super unleaded).
z Avoid spilling petrol.
z Do not inhale the vapour.
Hang up collection bag
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the reces-
ses (see arrow).
3. Replace the protective flap.
G
B
H
(1).
J
.
L
z Wear suitable work gloves when carrying out the above work,
especially when handling the blade.
Mount grass catcher
z See illustrations.
Set cut height
M
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
1. Place hand into handle bar and depress button (1).
2. Lift or lower chassis until it engages into required position (2).
Selection of Cutting height
z If possible, mow when grass is dry in order to protect turf. Do
not se cutting position too low when mowing very hight or wet
grass.
z We recommend an average cutting height of 40-50 mm.
Start
z On a flat surface, if possible not in high grass.
Cold start
1. Firmly press the primer on the motor three times
2. Raise and hold the safety bracket
J
3. Pull starter grip and return it slowly by hand.
Wheel drive
1. Wheel drive on: Raise drive bracket
2. Wheel drive off: Relapse drive bracket
Warm start
1. Raise and hold the safety bracket
J
2. Pull starter grip and return it slowly by hand.
Stop Motor
z Release safety bracket
3
Notes:
z If the motor does not start in cold weather, press the pri-
mer.
z If the motor stops due to lack of fuel, refi ll with fuel and
press the primer firmly (three times).
C D E F G
N
H
(1).
H (2).
H
(2).
H
(1).
H
(1).
.
13