Gas Valves; Burners And Spark Ignitors; Proximity Switches - Pitco frialator MG14S-C/MFD Serviceanleitung

Install of the reverse order.

Gas Valves:

1. Unscrew the fittings to the gas outlet tubes at the
top of the gas valve.
2. Unscrew the pipe union, located behind the gas
valve.
3. Unplug the 3 wires that plug into the gas valve.
Install in the reverse order.

Burners and Spark Ignitors:

NOTE: If the ignitor is to be removed without the
burner start the proceedure at step 2.
1. Unscrew the fitting for the gas supply tubing on
the bottom of the burner.
2. Unplug the wire to the spark ignitor.
3. Remove the 2 screws that hold the spark ignitor
and burner in place.
The burner and spark ignitor may be removed to-
gether. Install in the reverse order.

Proximity Switches:

1. The actuator can be removed by removing the 2
mounting screws.
2. The sensor may be removed by disconnecting the
wiring harness and by removing the 2 mounting
screws.
Install in the reverse order.
10