Blowers; Pressure Switches - Pitco frialator MG14S-C/MFD Serviceanleitung

Blowers:

1. Unplug the wiring connector.
2. Remove the 3 screws from the mounting flange.
3. Using a flat screwdriver, break the seal at the
motor flange.
4. The motor can now be lowered out of the ma-
chine.
NOTE: The new blower will be shipped with the
blower housing attached. Remove the motor from the
blower housing in the above manner. Clean the seal-
ant from the new motor and the old housing (still at-
tached to the machine). Apply a small amount of high
temperature silicone sealant to the motor mounting
flange.
Install the motor in the reverse order of removal.

Pressure Switches:

1. Unscrew the plastic fitting from the air connec-
tion on the pressure switch.
2. Unplug the 2 wires from the switch.
3. Remove the 2 screws from the mounting bracket.
Install in the reverse order.
11