Replacing The Lens - Sony VPL-PX41 Installationsanleitung

Replacing the Lens

You can install the following types of lenses in the
projector.
• VPLL-ZM102 Long Focus Zoom Lens
• VPLL-ZM32 Short Focus Zoom Lens
Follow the steps below to replace the lens.
For details on replacing the lens, also refer to the
installation manual supplied with the lens.
1
Turn off the power and disconnect the power
cable.
2
Remove the screw from the bottom of the unit by
using a Philips screwdriver.
(single long screw (M3))
3
Slide the top cover (top lens cover) forward, and
then lift it up to remove.
4
Remove the four screws (M3×10, with washers)
locking the lens.
5
Lift and remove the lens.
6
Align the positions so that the stopper for the new
lens is in contact with the stopper of the projector
unit, and then attach the lens.
Stopper
(Projector)
Stopper
(Lens)
Note
When attaching the lens, mount the stopper (lens side)
attached to the lens so that it is visible from the top.
7
Secure the replacement lens in place with four
screws (M3×10, with washers).
8
Line up the bump under the lens on the top cover
with the depression in the base (refer to the
diagram below), and then insert the six tabs on the
sides of the top cover into the slits on the
projector.
Stopper
(Projector)
Stopper
(Lens)
13