Replacing The Lens - Sony VPL-FX52 Installationsanleitung

On cleaning
• To keep the cabinet looking new, periodically clean
it with a soft cloth. Stubborn stains may be removed
with a cloth lightly dampened with a mild detergent
solution. Never use strong solvents, such as thinner,
benzene, or abrasive cleansers, since these will
damage the cabinet.
• Avoid touching the lens. To remove dust on the lens,
use a soft dry cloth. Do not use a damp cloth,
detergent solution, or thinner.
• Clean the filter at regular intervals.
On repacking
Save the original shipping carton and packing
material; they will come in handy if you ever have to
ship your unit. For maximum protection, repack your
unit as it was originally packed at the factory.
Overview
This manual describes how to install the Sony Data
Projector VPL-FX52/FX52L, how to replace the lens
and installation diagrams. When you replace the lens,
also refer to the Operating Instructions.

Replacing the Lens

You can install the following three types of lenses in
the projector.
• VPLL-ZM101 Long Focus Zoom Lens
• VPLL-ZM31 Short Focus Zoom Lens
• VPLL-FM21 Fixed Short Focus Lens
Notes
When you are going to use the optional VPLL-FM21
fixed short focus lens, check that:
• the product code mentioned on the seal located on
the upper right of the package is "P-93817601."
If the product code is "P-93817600," the lens cannot
be used with this projector.
• the product code mentioned on the seal located on
your lens is "P-93817601."
If no product code is mentioned on the lens, the lens
cannot be used with this projector.
10
Downloaded from: https://www.usersmanualguide.com/
Follow the steps below to replace the lens.
For VPL-FX52 (with standard lens): Perform the
operations in steps 1 to 7 and 9 to 14.
For VPL-FX52L (Lens are not supplied.): Perform
the operations in steps 1,2,3,6,8-10,13-14.
For details on replacing the lens, also refer to the
installation manual supplied with the lens.
1
Turn off the power and disconnect the power
cable.
2
Loosen the two screws on the lens cover using a
Phillips screwdriver.
3
Remove the lens cover by sliding it forward, then
lifting it.
4
Release the connector cables from the cable binder
by opening it.
Skip this step and the next when replacing a lens
other than the standard one.
5
Disconnect the two connectors on the lens from
those on the projector.
Lens cover
Cable binder