Sanitas SBC 53 Gebrauchsanweisung Seite 32

• To clear the memory of the relevant user memory, you
must first select a user memory.
• Start the retrieval of the average measured values.
A flashes on the display and the average value of all
saved measured values in this user memory is dis-
played.
• Press and hold the memory button M1 or M2 for 5
seconds depending on the user memory you are in.
All the values in the current user memory are
deleted.
®
If Bluetooth is activated (the
es on the display), the blood pressure monitor
attempts to connect to the app. When the
symbol is flashing, it is not possible to de-
lete all values from the selected user memory.
symbol flash-
To clear individual measurements from the relevant user
memory, you must first select a user memory.
• Start the retrieval of the individual measured values.
• Press and hold the memory button M1 or M2 for 5
seconds (depending on the user memory you are in).
• The selected value is deleted. The device briefly dis-
plays CL 00.
• If you would like to delete other values, repeat the pro-
cess described above.
You can switch off the device at any time by pressing the
START/STOP
Transfer via Bluetooth
It is also possible to transfer the measured values saved on the
device to your smartphone using Bluetooth
You will need the HealthCoach app for this. The app is availa-
ble from the App Store.
Proceed as follows to transfer values:
®
If Bluetooth is activated in the settings menu, the data is
transferred automatically after the measurement. The
appears in the top left of the display (see chapter 4 „Preparing
the measurement").
32
button.
®
®
.
symbol