Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Lubricating drive shaft
1. Shaft tube
2. Flexible shaft
3. Shield
Checking the nylon line cutting head
Do not disassemble the recoil starter ("ES-Start")
NOTE
When starter grip cannot be pulled lightly, the trouble is diagnosed as failure of engine inside. Please consult your dealer. If dis-
assembled inadvertently, it can cause injury.
4. Screw
5. Bearing housing
Maintenance and care
1.
Remove shield.
2.
Loosen bearing housing locating screw, at the top of the
housing, remove mounting screw.
3.
Pull flexible shaft from the shaft tube, wipe clean and recoat
with a thin coating 10 to 20 g, of lithium base grease.
4.
Slide the flexible shaft back in the shaft tube. DO NOT get
dirt on the flexible shaft.
5.
Install the bearing housing and shield.
1.
Make sure each periphery of the 2 retaining pawls of housing
spreads almost fully up to the outer periphery of the respec-
tive cover window.
2.
Check mount of cutting head on trimmer and tighten if it is
loose.
3.
Check the cutter head for deflection or abnormal noise rotat-
ing it by hand.
Deflection or abnormal noise can cause abnormal vibration
to occur or mount to trimmer to loosen during rotation which
is dangerous.
4.
Inspect cover and tap knob for wear.
When slot appears on bottom of the tap knob or when slot
appears on cover bottom close to outlet for nylon line, re-
place them with new parts without fail.
5.
Check the cutting head for crack or chip.
Replace parts that show any crack or chip with new ones
without fail.
29
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
