Starting A Warm Engine; Stopping The Engine - Echo GT-220ES Bedienungsanleitung

Engine warm-up

Starting a warm engine

1. Ignition switch
2. Throttle trigger
1.Purge bulb
2.Choke knob

Stopping the engine

1. Ignition switch
3. Throttle trigger lockout
3.Fuel return line
4.Starter handle
2. Throttle trigger
Engine operation
1. Once the engine starts, allow it to warm up for 2 to 3 minutes
at idling (i.e. low speed).
2. Warming the engine helps to lubricate its internal workings
more smoothly. Allow the engine to warm up fully, especially
when it is cold.
3. Never run the engine without the cutting attachment fitted.
1. Move the ignition switch to the Start position.
2. Make sure that the throttle trigger is at the idle speed posi-
tion.
3. Check that the choke knob is in the Open position.
4. If fuel tank is not empty, pull on the starter grip to start the
engine.
5. If no fuel is visible in the purge bulb, alternately press and re-
lease the purge bulb until the fuel is sucked up into it.
6. Checking that the area around you is safe, hold the position
closest to the engine firmly as shown in the illustration, and
pull on the starter grip to start the engine.
1. Move the throttle trigger to the idle speed position and set
the engine to idling (i.e. low speed).
2. Move the ignition switch to the Stop position.
3. In the event of an emergency, stop the engine immediately
using the ignition switch.
4. If the engine fails to stop, move the choke knob to the Closed
position. The engine will stall and come to a halt (a choke
stop).
∗ If the engine fails to stop when the igniton switch is used, have
the ignition switch checked and repaired by your ECHO DEAL-
ER before you use the product again.
21