Echo GT-220ES Bedienungsanleitung Seite 12

Remove foreign objects and obstructions before working with the
product
Before starting work, check the area where you will be working and re-
move any small stones and empty cans likely to ricochet off the cutting
attachment, as well as any pieces of string or wire that might become
twisted around the cutting attachment.
An accident or serious injury can occur if foreign objects ricochet off the cut-
ting attachment or wire and other materials twisted round the product spring
off it.
Do not hold the cutting attachment up when working with the product
Do not hold the cutting attachment up while you work. You must not work with the cutting attachments raised above
knee level.
Raising the cutting attachment above knee level brings the plane of rotation closer to the face, and any objects that fly off the
cutting attachments could cause an accident or serious injury.
Turn off the engine immediately if anything goes wrong
In the following situations, turn off the engine immediately and ensure that the cutting attachments have stopped be-
fore checking each area of the product. Replace any damaged parts.
If the cutting attachment hits a rock, tree, post, or other such obstruction while you work.
If the product suddenly starts to vibrate abnormally.
Continuing to use parts when they are damaged could lead to an accident or serious injury.
Precautions concerning the cutting attachment
Always stop the engine when a cutting attachment jam occurs. Do not attempt to remove an object causing a jam if the
engine is running. Severe injury can occur if a jam is removed and the cutting attachment suddenly starts.
1.With nylon line cutting head
Use correct cutting attachment
Serious injury may result from the improper use of cut-
ting attachment.
Read and comply with all safety instructions listed in
this manual.
Use only cutting attachments recommended by KIOR-
ITZ CORPORATION.
Use only nylon line cutting head. Do not use any type of
metal blade.
Failure to do so could lead to an accident or serious injury.
Excessive nylon line beyond cut off knife could fly off
when the nylon line cutting head starts rotating after ad-
justment of nylon line length.
Failure to do so could lead to an accident or injury.
Use only flexible, non-metallic line recommended by KIORITZ CORPORATION.
For safe use of your product
WARNING
DANGER
WARNING
Do not trim near cars or pedestrians
Use extreme caution when operating over bare spots and
gravel, because the line can throw small rock particles at
high speeds. The shield on the unit cannot stop objects
which bounce or ricochet off hard surfaces.
Failure to do so could lead to an accident or serious injury.
Avoid wire
Do not trim in any area where there are broken strands of
fencing wire. Remove the broken pieces of wire, or give the
area wide berth. Wear proper safety protection. Do not cut
where you cannot see what the cutting device is cutting.
Failure to do so could lead to an accident or serious injury.
CAUTION
11