Before You Start; Assembly - Echo GT-220ES Bedienungsanleitung

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
1. Loop handle
2. Screw M5×35
1. Shield
2. Plastic sleeve
3. Cut off knife
4. Bolt
WARNING
3. Nut
5. Bearing housing
6. Washer
7. Wing nut
8. Output shaft

Before you start

Before you start
Loop handle assembly
Position handle in comfortable operating position and tighten
screws (M5×35). The cutting attachment should be 5 - 7.5 cm
above the ground and as level as possible.
Installation of shield
Cut off Knife on debris shield has sharp edges. Avoid
contact when installing or removing line head.
Failure to do so could lead to an injury or serious accident.
1. Remove plastic sleeve from output shaft.
2. Snap the shield over the bearing housing.
3. Install bolt, washer and wing nut.
15
WARNING