Safety Instructions; Description Of The Appliance - Kärcher T 250 T-Racer Originalbetriebsanleitung

Safety instructions

Please read and comply with
these original operating instruc-
tions prior to the initial operation and store
them for later use or subsequent owners.
 Please observe the safety instructions
of your high-pressure cleaner.
 Only trigger the high-pressure jet at the
high-pressure gun if the T-Racer is lo-
cated on the surface to be cleaned.
 There must be no persons in the imme-
diate vicinity of the cleaning head.
 Beware of the recoil force! Ensure a
stable position and firmly hold the high-
pressure gun with the extension tube or
the handle.
 Switch off the high-pressure cleaner
when you finish cleaning. If you are us-
ing the T-Racer then disconnect the
same from the high-pressure gun.
 Maximum water temperature 60°C
(please observe the instructions of your
high-pressure cleaner).
Danger!
Do not hold under the edge of the
T-Racer when it is on!
Proper use
The T-Racer is ideally suited for the clean-
ing of floor and wall surfaces made of differ-
ent materials, such as plastic, concrete,
tiles, and natural stone. Use the T-Racer
exclusively in your private household.
6
Symbols

Description of the Appliance

When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
 See page 2, illustration
1 Casing
2 Handle
3 Bayonet connection with safety cover
4 Extension tubes (two tubes)
5 Rotor arm
6 High pressure nozzle
Note: Always use Kärcher water filter (or-
der no. 4.730-059.0) during suction opera-
tions of the high-pressure cleaner.
Cleaning floor surfaces
Fasten the T-Racer to the high-pressure
gun using the extension pipes.
 Illustration
1 Press the extension pipe into the bayo-
net catch of the T-Racer.
2 Turn it by 90° until it locks into place.
3 Tighten the safety cover.
Repeat this process even for the other
–
joints.
Tips for cleaning
 Outdoor surfaces should be swept be-
fore the T-Racer is used to avoid dam-
aging the high-pressure nozzles.
 Prior to use on sensitive surfaces (e.g.
wooden surfaces), test the product on
an imperceptible spot, in order to
promptly detect any changes in the sur-
face.
 The T-Racer is not suited for scouring
or scrubbing!
Caution
 Illustration
Do not run over protruding corners!
EN
Application