Spraying; Spraying Technique - WAGNER F230 Betriebsanleitung

Spraying

Spraying Technique

The key to a good paint job is an even coating over the entire
surface. This is done by using even strokes. Keep your arm
moving at a constant speed and keep the spray gun at a
constant distance from the surface. The best spraying distance
is 10 to 12 inches between the spray tip and the surface.
Light Coat Heavy Coat
Keep the spray gun at right angles to the surface. This means
Do not flex wrist while spraying.
moving your entire arm back and forth rather than just flexing
your wrist.
Even coat throughout
Keep the spray gun perpendicular to the surface, otherwise
Keep stroke smooth and at an even speed.
one end of the pattern will be thicker than the other.
Approximately
10 to 12 inches
Right way
Wrong way
The spray gun should be triggered by turning it on and off with
each stroke. This will save material and avoid material buildup
at the end of the stroke. Do not trigger the gun during the
middle of a stroke. This will result in an uneven spray and
splotchy coverage.
R
Light Coat
Approximately
10 to 12 inches
GB
Proper way to trigger the spray gun
Keep stroke
even
Start stroke Pull trigger
Overlap each stroke by about 30%. This will ensure an even
coating.
When you stop painting, lock the gun trigger lock, turn the
pressure control knob counterclockwise to its lowest setting
and set the PRIME/SPRAY valve to PRIME. Move the motor
ON/OFF switch to OFF and unplug the sprayer.
If you expect to be gone more than 1 hour, follow the short
term clean up procedure described in the CLEANUP section of
this manual.
Practice
1. Be sure that the paint hose is free of kinks and clear of
objects with sharp cutting edges.
2. Turn the pressure control knob counterclockwise to its to
its lowest setting.
Pressure Control Knob
PRIME/SPRAY Valve
3. Turn the PRIME/SPRAY valve to SPRAY.
4. Turn the pressure control knob clockwise to its highest
setting. The paint hose should stiffen as material begins
to flow through it.
5. Unlock the gun trigger
lock by turning the
switch so that it is
parallel to the handle.
6. Trigger the spray gun to
bleed air out of the
hose.
7. When material reaches
the spray tip, spray a
test area to check the
spray pattern.
8. Use the lowest pressure setting necessary to get a good
spray pattern. If the pressure is set too high, the spray
pattern will be too light. If the pressure is set too low,
tailing will appear or the paint will spatter out in blobs
rather than in a fine spray.
6
Aproximately
10 to 12 inches
Keep steady Release trigger
Good spray pattern
Paint tailing pattern
© Wagner. All rights reserved.
End stroke