Maintenance And Care - Kärcher NT 48/1 TE Handbuch

Note: Please refer to "Technical specifica-
tions" for the power connection specifica-
tions of the power tools.
Illustration
Adjust the stepped power tool adaptor to fit
the connection of the electric power tool.
Illustration
Remove the elbow from the suction hose.
Attach the stepped power tool adaptor to
the suction hose.
Illustration
Connect the adaptor to the electric power
tool.
Emptying the dirt container
Caution
Please observe the local provisions regard-
ing the wastewater treatment.
The vacuum channel is equipped with a
–
float.
When the dirt water reaches the highest
–
permissible level in the container, the
suction power is interrupted.
Switch off the appliance at the main
switch.
Illustration
Drain off dirty water through the drain-
age hose.
Turn off the appliance.
Switch off the appliance at the main
switch.
Pull out the mains plug.
After each operation
Empty the dirt container.
Vacuum and wipe the appliance inside
and outside with a damp cloth.
Storing the Appliance
Store the suction pipes, the suction
hose and the mains cable as shown in
the illustration.
Place the appliance in a dry room and
secure it from unauthorized use.
14
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
Hold the appliance at the handle and at
the suction pipe to transport it.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in interior
rooms.

Maintenance and care

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Change cartridge filter
Release and remove the suction head.
Turn the suction basket by 180° and
keep it aside.
Loosen the mounting nuts
Remove the cartridge filter.
Insert the new cartridge filter.
Insert the fastening nut and tighten it.
Insert and lock the suction head.
Troubleshooting
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Suction turbine does not run
Check cables, plugs, fuse, and socket.
Turn on the appliance.
Vaccum turbine is running but the
machine is not sucking in dust/dirt
Float is blocking the suction canal.
–
Empty the dirt container.
3
-
EN
Transport
Storage