AGFEO T 18
Basic settings on first connection
When you connect the unit for the first time, you will be guided through the full settings
menu (Language/LCD Contrast/Date/PABX Prefix/Ringer Melody/Ringer Vol./Flash Settings/
T1/T2/T3). You can skip these basic settings at any time by pressing the "Esc" (
You can call up all these settings later, using the "Menu" (
which they are described below.
Settings options
Language
LCD contrast
Date/time
PABX Prefix
Ringer Melody
Ringer Volume
Short Flash
(R button)
T1, T2, T3
26
Set your desired language here so that all operating instructions
will appear on the display in the language you choose.
Contrast can be set at any of five levels here. This enables you to
adjust the contrast to your angle of view.
Enter date and time in a block. Confirm each entry with Ok, other-
wise the new time and date will not be saved. Note that time and
date (except year) can be automatically regulated by transfer of
CLIP data.
Enter the number here that you need to key in to obtain an outside
line on the public telephone network (e.g. 9). To prevent wrong
numbers, your telephone will automatically insert a dialling pause
after the outside line code if you key in the number(s) that are
stored as the outside line code.
Choose one of the sixteen available ringtones here.
Set the desired ringtone volume level here. There are eight levels
available.
Select short or long. For PBXs, short flash (approx. 100 ms) is
generally used for initiating functions. On the Deutsche Telekom
network, however, the long flash (approx. 240 ms) is used. No
change to the default value is needed for operation on AGFEO
PBXs.
Set the times for the special ringtone for the message display
(MWI) here. To deactivate the function, set all times to "000". No
change to the default values is needed for operation on AGFEO
PBXs.
) button , in the sequence in
) button.