Troubleshooting - Kärcher HD 10/15-4 Cage Food Handbuch

Safety inspection/ maintenance
You can sign with your dealer a contract for
regular safety inspection or even sign a
maintenance contract. Please take advice
on this matter.
Before each use
 Check connection cable for damages
(risk of electrical shock); get the dam-
aged connection cable replaced imme-
diately by an authorised customer ser-
vice person/ electrician.
 Check the high pressure hose for dam-
ages (risk of bursting).
Please arrange for the immediate ex-
change of a damaged high-pressure
hose.
 Check appliance (pump) for leaks.
3 drops per minute are permitted and
can come out from the lower side of the
appliance. Call Customer Service if
there is heavy leakage.
 Check oil level Please contact Custom-
er Service immediately if the oil is milky
(water in oil).
 Clean water filter.
 Clean filter at the detergent suck hose.
Every 500 operating hours, at least
 Have the maintenance of the device
performed by the customer service.
 Get customer service to change the oil.
Note:
See "Specifications" for oil volume and type.
16
contract
Weekly
annually

Troubleshooting

DANGER
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
– Prior to all work on the appliance,
switch off the appliance and pull the
power plug.
– Get the electrical components checked
and repaired only by authorised cus-
tomer service persons.
– Contact an authorised customer service
person in case of problems not men-
tioned in this chapter or if you are in
doubt or when you have been explicitly
asked to do so.
Appliance is not running
 Check connection cable for damages.
 Check the supply voltage.
 Lack of water fuse was triggered:
Check the water input, open the tap,
have the lack of water fuse tested by
customer service.
 Call Customer Service in case of elec-
trical defects.
Pressure does not build up in the
 Install the high pressure or rotor nozzle
on the spray pipe.
 Clean the nozzle.
 Replace the nozzle.
 Deaerate the appliance (see "Start-up")
 Unscrew the locking screw of the ad-
vance pump with a screwdriver through
the opening in the advance pump.
Loosen the shaft of the advance pump
by turning it.
Screw in the lock screw and tighten it.
 Check water supply level (refer to tech-
nical data).
 Clean water filter.
 Check all inlet pipes to the pump.
 Contact Customer Service if needed.
– 6
EN
appliance