Care And Cleaning - Gastroback 42435 Bedienungsanleitung

The power base gets
unexpectedly hot during
operation.

CARE AND CLEANING

WARNING:
and leave the appliance cool down, before cleaning the appliance. Always ensure
that all parts of the appliance
Do not spill or pour any liquids on or in the power base or power cord. Do not place
or immerse the appliance or any part of it in any liquids to avoid damage, risk of
fire, and electric shock.
power connector in the bottom of the kettle always completely dry.
clean the power socket or the power connector, to avoid damage.
Do not use abrasive cleaning agents or aggressive liquids (e.g. bleach, solving
agents) for cleaning the appliance or any part of it, to avoid damage to the surfaces
and seals. Do not use any hard or sharp-edged objects for cleaning (e.g. scoring
pads, knives, scrapers). Do not use violence.
DO NOT clean the appliance or any part of it in an automatic dishwasher!
Depending on the water hardness and the frequency of usage, the interior of the
kettle gets coated with grey or sand-coloured scale. To keep the appliance always
ready for usage, and to avoid damage to the heating elements, you should de-scale
the kettle in time (see: 'De-scaling the Kettle').
42
The power cord has been
wound partly around
the cable storage during
operation.
The power socket in the
centre of the power base
or the pins at the bottom
of the kettle are dama-
ged or corroded.
The power cord is
damaged.
Always switch OFF (lift the kettle from the power base), unplug,
are out of reach of young children
Especially keep the power socket at the power base and the
Always unwind the power cord completely before
operation to avoid overheating.
Immediately unplug the appliance. Check the power
connector at the bottom of the kettle and the power
socket of the power base for discolouration, distortion,
or corrosion. Do not use the appliance again, if the pins
are not smooth and clean. There is no use in trying to
clean or repair the pins of the power connector as the
power socket in the power base will be affected as
well.
Contact an authorised service centre for replacement.
.
Do not attempt to