Gastroback 42435 Bedienungsanleitung Seite 41

"-H" is shown on the
display and a long signal
sounds.
Water accumulates under
the power base or runs
down on the exterior of
the kettle.
You cannot change the
set temperature.
The appliance goes back
to standby mode, imme-
diately after starting a
heating cycle.
The overheat protection
system has been
triggered.
There is too much water
in the kettle.
You spilled some water
when filling or moving
the kettle.
The kettle is leaking.
There is no way to chan-
ge the current settings
with a heating cycle run-
ning (ON/OFF button is
illuminated in red).
The actual water tempe-
rature is above or equal
to the set temperature.
The kettle has been operated without water or with too
little water. Empty the kettle and leave it cool down
for at least 30 minutes. If required, de-scale the kettle.
Thereafter, fill the kettle with at least 0.3 litres of cold
water and try again.
Immediately unplug the appliance. Then wipe dry the
appliance completely. Always observe the MAX filling
level when filling (1.0 litres).
Immediately unplug the appliance. Then wipe dry
completely. Ensure not to spill water on the exterior
of the kettle during filling. Always ensure to hold the
kettle level when it is filled.
Immediately unplug the appliance and wipe dry the
appliance completely. Then check the kettle for
leakage (fill up and leave stand over night). Do not use
the appliance, if the kettle is leaking.
Press the ON/OFF button to cancel the running heating
cycle (ON/OFF button gets dark). Then try again.
For starting a heating cycle, the actual water tempera-
ture must be at least 5°C below the set temperature.
Raise the set temperature or wait until the appliance
cooled down. Then try again.
41