Start Working; Park Position; Finish Operation - Kärcher DS 6.000 Bedienungsanleitung

Start working

Illustration
 Pull the power cable out of the appli-
ance completely.
Illustration
 Insert the appliance plug into the mains
socket.
 To switch on the appliance press the
on/off switch.
Caution
Do not vacuum up large amounts of pow-
dery materials such as cocoa, flour, laundry
detergent, pudding powder or similar mate-
rials!
Working with the floor nozzle
Vacuuming hard surfaces
Illustration
 Use your foot to press the reversing
switch of the floor nozzle. The brush
strips at the bottom of the floor nozzle
are extended.
Vacuuming carpeted floors
Illustration
 Use your foot to press the reversing
switch of the floor nozzle. The brush
strips at the bottom of the floor nozzle
are retracted.
Note
Due to the high suction power of the appli-
ance, the suction nozzles can draw them-
selves too firmly to carpets, upholstery, etc.
during work. In this case, use the false air
slide to reduce the suction power. Close it
again after use.
Working with the crevice nozzle and
the upholstery nozzle
Note: The crevice and upholstery nozzles
are stored in the appliance.
Illustration
 Open the accessories flap and take out
the desired nozzle for working.
Crevice nozzle
for edges, joints, heaters and hard to reach
locations.
Upholstery nozzle
for cleaning upholstered furniture, laced
curtains, mattresses, etc.
Turbo floor nozzle
* depending on model
Illustration
 Turbo floor nozzle
(order no. 4.130-177.0)
brush and vacuum in one work cycle.
Especially suitable in order to pick up
animal hair and to vacuum high floor
carpets. The drive of the brush roller
happens by the air stream.
There is not electrical outlet necessary.
Illustration
 Switch off the appliance; press the on/
off foot switch to do so.
Illustration
 Insert the floor nozzle into the pickup on
the appliance when taking a break.

Finish operation

Illustration
 Turn off the appliance and disconnect
the mains plug.
Illustration
 The cable is automatically retracted into
the appliance by slightly pulling on the
power cord.
Cleaning the water filter system
Caution
Rinse the water filter container, the filter
cover and the baffle plate under running
water after each use and allow them to dry.
Make sure that the guides of the baffle plate
are also clean.
Illustration
 Remove the water filter reservoir from
the appliance (see: FILLING THE WA-
TER FILTER RESERVOIR).
Illustration
 Remove the lid from the reservoir and
take out the baffle plate.
 Empty the water filter container.
 Rinse the cover, the baffle plate and the
water filter container under running wa-
ter and allow them to dry.
– 8
EN

Park position

15