Basics; Faceplate; Getting Started; Select The Display Language And Cancel The Demonstration - Kenwood KDC-X5200BT Bedienungsanleitung

BASICS

Faceplate

Volume
knob
Detach
button
Note: The highlighted area on the faceplate flashes when the unit enters searching status.
Attach Detach
To
Turn on the power
Adjust the volume
Select a source
Change the display information
Display Lights up when Bluetooth
window connection is established. ( 11)
Auxiliary cable from the rear of the unit.
USB cable from the rear of the unit.
How to reset
Reset the unit within
5 seconds after
detaching the faceplate.
On the faceplate
Press .
• Press and hold to turn off the power.
Turn the volume knob.
Press repeatedly.
Press DISP repeatedly. ( 26)

GETTING STARTED

1
Select the display language and cancel the
demonstration
When you turn on the power for the first time
(or [FACTORY RESET] is set to [YES],
"SEL LANGUAGE" "PRESS" "VOLUME KNOB"
1 Turn the volume knob to select [ENG] (English), [RUS]
(Russian) or [SPA] (Spanish), then press the knob.
[ENG] is selected for the initial setup.
Then, the display shows: "CANCEL DEMO" "PRESS"
"VOLUME KNOB".
2 Press the volume knob.
[YES] is selected for the initial setup.
3
Press the volume knob again.
"DEMO OFF" appears.
Then, the display shows the selected crossover type:
"2-WAY X ' OVER" or "3-WAY X ' OVER"
• To change the crossover type, see "Change the crossover
type". ( 5)
5), the display shows:
3
ENGLISH