Installation/Connection - Kenwood KDC-X5200BT Bedienungsanleitung

REFERENCES
Change the display information
Each time you press DISP, the display information changes.
• If the information is unavailable or not recorded, "NO TEXT", "NO INFO", or other information
(eg. station name, playing time) appears.
Source name
STANDBY Source name (Date)*
RADIO Frequency (Date)*
(For FM Radio Data System stations only)
Station name (Date)*
Song title (Artist)
(back to the beginning)
CD or USB (For CD-DA)
Track title (Artist)
Playing time (Date)*
(For MP3/WMA/AAC/WAV/FLAC files)
Song title (Artist)
File name (Folder name)
(back to the beginning)
iPod USB/iPod BT When [MODE OFF]/[BROWSE MODE] is selected ( 8):
or ANDROID Song title (Artist)
Playing time (Date)*
SPOTIFY/ Context title (Date)*
SPOTIFY BT name) Song title (Date)*
beginning)
BT AUDIO Song title (Artist)
Playing time (Date)*
AUX Source name (Date)*
* Battery and signal strength of the Bluetooth device will be shown if
[BATTERY/SIGNAL] is set to [AUTO]. ( 13)
26
ENGLISH
Display information
Radio text (Date)* Radio text+ (R.TEXT+)
Song title (Date)* Frequency (Date)*
Track title (Disc name) Track title (Date)*
(back to the beginning)
Song title (Album title) Song title (Date)*
File name (Date)* Playing time (Date)*
Song title (Album name) Song title (Date)*
(back to the beginning)
Song title (Artist) Song title (Album
Playing time (Date)* (back to the
Song title (Album name) Song title (Date)*
(back to the beginning)

INSTALLATION/CONNECTION

Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• To prevent short-circuit:
– Insulate unconnected wires with vinyl tape.
– Be sure to ground this unit to the car's chassis again after installation.
– Secure the wires with cable clamps and wrap vinyl tape around the wires that come into
contact with metal parts to protect the wires.
Caution
• For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the [ wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned
on and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old
fuse with one that has the same rating.