INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate
(C) Mounting sleeve
(E) Extraction key
Basic procedure
1 Remove the key from the ignition switch, then disconnect the [
terminal of the car battery.
2 Connect the wires properly.
See Wiring connection. ( 28)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the [ terminal of the car battery.
5 Press
to turn on the power.
6 Detach the faceplate and reset the unit within 5 seconds. ( 3)
(B) Trim plate
(D) Wiring harness
Installing the unit (in-dash mounting)
Hook on the top side
Orientate the trim
plate as illustrated
before fitting.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into
the holes on both sides of the trim plate, then
pull it out.
3 Insert the extraction keys deeply into the
slots on each side, then follow the arrows as
shown on the illustration.
Do the required wiring.
( 28)
Dashboard of
your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
ENGLISH
27