Troubleshooting - Kenwood KDC-X5200BT Bedienungsanleitung

TROUBLESHOOTING

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN POWER ON" appears.
"PROTECTING SEND TO
SERVICE" appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all.
• Radio reception is poor.
• Static noise while listening
to the radio.
Disc cannot be ejected.
Noise is generated.
Tracks do not play back as you
intended them to play.
"READING" keeps flashing.
Elapsed playing time is not
correct.
"LOADING" appears when you
enter search mode by pressing
.
22
ENGLISH
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the
terminals of the speaker wires are insulated properly.
Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 24)
Reset the unit. ( 3)
Connect the antenna firmly.
Press and hold M to forcibly eject the disc. Be careful
not to drop the disc when it is ejected. If this does not
solve the problem, reset the unit. ( 3)
Skip to another track or change the disc.
Playback order is determined when files are recorded.
Do not use too many hierarchical levels or folders.
This is caused by how the tracks are recorded.
This unit is still preparing the iPod/iPhone music list.
It may take some time to load, try again later.
Symptom Remedy
Correct characters are not • This unit can only display uppercase letters,
displayed (e.g. album name).
• Depending on the display language you have
"NA FILE" Make sure the media contains supported audio files.
( 25)
"NO DISC" Insert a playable disc into the loading slot.
"TOC ERROR" Make sure the disc is clean and inserted properly.
"PLEASE EJECT" Reset the unit. If this does not solve the problem,
consult your nearest service center.
"NO DEVICE" Connect a USB device, and change the source to USB
again.
"COPY PROTECTED" A copy-protected file is played.
"UNSUPPORTED DEVICE" • Check whether the connected device is compatible
• Reattach the device.
"UNRESPONSIVE DEVICE" Make sure the device is not malfunction and reattach
the device.
"USB HUB IS NOT This unit cannot support a USB device connected via
SUPPORTED" a USB hub.
• The source does not The USB port is drawing more power than the design
change to "USB" when limit. Turn the power off and unplug the USB device.
you connect a USB device Then, turn on the power and reattach the USB device.
while listening to another If this does not solve the problem, turn the power
source. off and on (or reset the unit) before replacing with
• "USB ERROR" appears. another USB device.
numbers, and a limited number of symbols.
selected ( 5), some characters may not be
displayed correctly.
with this unit and ensure the file systems are in
supported formats. ( 25)