References; Maintenance; More Information - Kenwood KDC-X5200BT Bedienungsanleitung

TROUBLESHOOTING
Symptom Remedy
Sound is being interrupted • Reduce the distance between the unit and the
or skipped during playback
of a Bluetooth audio • Turn off, then turn on the unit and try to connect
player.
• Other Bluetooth devices might be trying to connect to
The connected Bluetooth • Check whether the connected Bluetooth audio player
audio player cannot be
controlled.
• Disconnect and connect the Bluetooth player again.
"DEVICE FULL" The number of registered devices has reached its limit.
Retry after deleting an unnecessary device. ( 15,
DEVICE DELETE)
"N/A VOICE TAG" Make sure the same voice as the registered voice tag
is used.
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature or phonebook transfer.
"NO ENTRY"/"NO PAIR" There is no registered device connected/found via
Bluetooth.
"ERROR" Try the operation again. If "ERROR" appears again, check
if the device supports the function you have tried.
"NO INFO"/"NO DATA" Bluetooth device cannot get the contact information.
"HF ERROR XX"/ Reset the unit and try the operation again. If this does
"BT ERROR" not solve the problem, consult your nearest service
center.
"SWITCHING NG" The connected phones might not support phone
switching feature.
24
ENGLISH
Bluetooth audio player.
again.
the unit.
supports Audio/Video Remote Control Profile (AVRCP).
(Refer to the instructions of your audio player.)

REFERENCES

Maintenance

Cleaning the unit
Wipe off dirt on the faceplate with a dry silicone or soft cloth.
Cleaning the connector
Detach the faceplate and clean the connector
gently with a cotton swab, being careful not to
damage the connector.
Handling discs
• Do not touch the recording surface of the disc.
• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
• Do not use any accessories for the disc.
• Clean from the center of the disc and move outward.
• Clean the disc with a dry silicone or soft cloth. Do not use any solvents.
• When removing discs from this unit, pull them out horizontally.
• Remove burrs from the center hole and disc edge before inserting a disc.

More information

For: – Latest firmware updates and latest compatible item list
– KENWOOD original application
– Any other latest information
Visit <www.kenwood.com/cs/ce/>.
General
• This unit can only play the following CDs:
• For detailed information and notes about the playable audio files, visit
<www.kenwood.com/cs/ce/audiofile/>.
Connector (on the reverse
side of the faceplate)