elv FHT8-Set Bedienungsanleitung Seite 71

h) Displaying the valve position ("StEL")
After selection of this menu item the approximate percent­
age of the valve opening is displayed on the heating control
(for valve operating mechanism 1 only).
• Press the "PROG" key until "Sond" is displayed.
• Use the selection wheel to select the special function
"StEL".
• To confirm your selection, briefly press the "PROG" key.
• The display shows the valve opening in percent ("%").
• Press the "PROG" key to quit the function.
i) Switching between display of the desired
temperature and the actual temperature ("t-An")
In the works, the desired temperature (i.e. the maximum
temperature the heating control permits the room temper­
ature to reach) is displayed on the right side of the large
display of the "FHT8R" heating control. You can use the
special function "t­An" to activate a mode displaying the
actual temperature (i.e. the currently measured room tem­
perature).
In this mode the desired temperature is only displayed if
you turn the selection wheel. To indicate that the displayed
temperature is the desired temperature the temperature unit
(°C or °F) flashes.
If the set value is not changed for several seconds, the
heating control automatically returns to the display of the
actual temperature.
Proceed as follows:
• Press the "PROG" key until "Sond" is displayed.
• Use the selection wheel to select the special function
71