elv FHT8-Set Bedienungsanleitung Seite 46

• no mounting next to a window
• greatest possible distance to metal objects to avoid any
unnecessary reduction of the operating range
b) Mounting the wall holder
Proceed as follows to mount the wall
holder:
• Remove the wall holder on the
back of the heating
control, slide it down for this.
• Place the wall holder vertically
against the wall
with the round side pointing up
(see picture).
• Mark the positions of the bores
through the two slotted holes.
• Depending on the type of wall drill two 6 mm holes and
insert suitable dowels.
When drilling the bores and tightening the screws
make sure not to damage any power lines or gas
or water pipes, etc.!
• Fix the wall holder using e.g. the enclosed screws. Pay at­
tention that the two recessed slotted holes for the screws
point in your direction.
• If not already done so, insert the batteries into the heating
control before you slide the heating control on the wall holder.
• Sliding of the heating control on the wall holder is now
possible from the top.
46