Environmental Protection; Repairs; Troubleshooting; Blind Rivet Is Not Set - Gesipa AccuBird Betriebsanleitung

GB
2.5

Environmental protection

If batteries need to be replaced, please observe the following:
• Return used GESIPA
• Never discard used batteries into household waste, fire or into water!
Caution!
In all EU countries (except Germany) the relevant national regulations for implementing
the EU guideline shall apply.
• In accordance with the EU Directive 2002/96/EC (WEEE), in Germany, this tool is
registered under the WEEE Reg.-No. DE 45695505. If the tool has an 8-digit serial num-
ber it can be returned free of charge to GESIPA
3.

Repairs

Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by skilled technical personnel. Failure to observe the
assembly and setting procedures and operation by non-skilled personnel may result in serious
damage to the riveting tool. In case of doubt, always send the riveting tool back to the supplier
or to GESIPA .
®
4.

Troubleshooting

4.1

Blind rivet is not set

Cause
Battery switched off because it has been idle
for longer than 21 days
Battery discharged
Jaws (No. 4) dirty or worn
Jaw mechanism loose
Compression spring weakened (No. 6)
Tool does not operate when yellow trigger
button is pressed (red indicator light)
24
rechargeable batteries to your dealer or to GESIPA
®
for correct disposal.
®
Corrective measures
Place battery in the charger for 2 minutes
(see 2.4)
Charge battery; replace if necessary
Clean and oil sliding surfaces or replace
(see 1.8)
Tighten (see 1.8)
Replace
(see 4.3)
for recycling.
®