IKEA Kulinarisk Gebrauchsanleitung Seite 25

ENGLISH
2. Fully press the clamping levers (A) on
the two door hinges.
3. Close the oven door to the first opening
position (approximately 70° angle).
4. Hold the door with one hand on each
side and pull it away from the appliance
at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface. This
is to prevent scratches.
6. Hold the door trim on the top edge of
the door at the two sides and push
inwards to release the clip seal.
7. Pull the door trim to the front to remove
it.
8. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
A
A
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence.
Make sure that you put the glass panels (A
and B) back in the correct sequence. The
first panel (A) has a decorative frame. The
screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel
frame (A) on the screen-printing zones is
not rough when you touch it.
A B
Replacing the lamp
Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
Warning! Danger of
electrocution! Disconnect the fuse
before you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
25