Troubleshooting - IKEA MEDELSTOR Anleitung

ENGLISH
5
D
Put the flat filter (A)
back in place. Make
sure that it is
correctly positioned
under the 2 guides
(D).
An incorrect position of the filters
can cause bad washing results
and damage to the appliance
Cleaning the filter of the inlet hose
1
Close the water tap.

Troubleshooting

If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you can
solve the problem by yourself with the help
of the information in the table.
6
Assemble filters (B)
and (C). Put them
into position in filter
(A). Turn the handle
clockwise until it
locks.
2
A
Disconnect the hose.
Press the lever B
and turn the
fastener A
clockwise.
3
Clean the filter of
the inlet hose.
Cleaning the spray arms
Do not remove the spray arms. If the holes
in the spray arms are clogged, remove
remaining parts of soil with a thin pointed
object.
External cleaning
• Clean the appliance with a moist soft
cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive
cleaning pads or solvents.
B
Internal cleaning
• Carefully clean the appliance, including
the rubber gasket of the door, with a soft
moist cloth.
• If you regularly use short duration
programmes, these can leave deposits of
grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration
programmes at least 2 times per month.
With some problems, the display shows
an alarm code.
18
4