Akkuschrauber_Arbeitsleuchte_450219.book Seite 50 Montag, 24. Februar 2014 2:58 14
GB
Note:
The revolution speed of the device
can be varied by applying different
pressures to the On/Off switch.
Drilling
DANGER!
Risk of injury!
Never hold the work piece that you
are working with in your hand, on
your lap, or against other body parts.
NOTICE!
Risk of damage to the unit!
Never use the drill for chasing or to
expand drilled holes.
– Turn the torque regulator (2) into posi-
].
tion [
– Hold the device straight and drill with
even pressure.
Note:
Always use a drill appropriate to the
material.
Screwdriver action
– Set the required torque using the torque
regulator (2).
– Keep the device in a straight line to the
screw.
Note:
Always use the screw bit designed
for the screw. If you use the incorrect
bit, you may damage the head of the
screw.
Battery-powered work light
Switching on and off
– Press the On/Off button (10).
Error/Fault
Device does not work.
50
– Press the On/Off button (10) again to
switch the device off.
Cleaning
Cleaning and maintenance at a
glance
Regularly and according to the operating
conditions
What?
Clean the ventilation
slots of the motor to
remove dust.
Clean the device.
Troubleshooting
What to do when something doesn't
work...
In many cases, small defects can lead to a
malfunction. You will usually be able to deal
with these yourself. Please refer to the table
below before contacting your local OBI store.
This may save you a lot of effort and quite
often money.
Cause
Is the device defective?
Battery pack discharged?
Battery pack defective?
How?
Use a vacuum,
cleaning brush or
paint brush.
Wipe the unit with a
damp cloth.
DANGER!
Risk of injury!
Unprofessional repairs may mean
that your unit will no longer operate
safely. This endangers you and your
environment.
Remedy
Contact your local OBI market.
► Charging the battery pack –
p. 48.
Contact your local OBI market.